Wanted to make a helldivers cosplay for comic con, found this great model by ZerekMasters that looked perfect.
However it had some problems like too many polygons and other misc. errors.
Fixed the models up in OrcaSlicer and sliced them into .3mf files for BambuLab A1 printers and .stl files for those that have different printers.
I used the standard 0.20mm profile, but i think it's definitely possible to use extra draft with ludicrous mode enabled. (I didn't use it because it was my first ever print with this printer and I had PTSD from my previous anycubic printer)
My head's on the larger side so I think it should fit most people.
If there are any problems feel free to comment them, I'll try to reply if I don't forget that this post exists.
| Helldiver_helmet_top.3mf | 2.8MB | |
| Helldiver_helmet_top.stl | 10.1MB | |
| helmet_bottom_1.3mf | 5.9MB | |
| helmet_bottom_1.stl | 22.8MB | |
| mask.3mf | 5.1MB | |
| mask.stl | 20.0MB | |
| Vents_and_locks.3mf | 14.3MB | |
| Vents_and_locks.stl | 3.0MB |
