Helldivers 2 Autocannon Cut Up Remix 3D Printer Model
The file 'Helldivers 2 Autocannon Cut Up Remix 3D Printer Model' is (stl) file type, size is 557.2KB.
The file 'Helldivers 2 Autocannon Cut Up Remix 3D Printer Model' is (stl) file type, size is 557.2KB.
All Credit to AdmiralForever
https://www.thingiverse.com/admiralforever/designs
This is just a Cut-Up version of AdmiralForever's Helldivers Autocannon
https://www.thingiverse.com/thing:6524811
For assembly I made a slot that I sized for a yardstick I got from a hardware store, but you could use anything about 36x6mm
I also cut away some of the pieces that would be harder to print attached, the scope, rail, grip, front rail, ect. some have slots to help keep the parts secure once assembled.
the largest single piece is "Fore p2" (282mm tall) I might upload a smaller cut if it gives me trouble. (Update: split Fore into "Fore p1" and "Fore p2" to fit in smaller beds)
no print yet (I'm doing my armor RN, Cannon is on the backlog) but let me know how it goes and I'll try to make adjustments if needed.
Good luck Helldivers
↓ ← ↓ ↑ ↑ →
| Barrel.stl | 43.1KB | |
| Butt.stl | 308.9KB | |
| FCG_Grip.stl | 239.2KB | |
| FCG_main.stl | 191.0KB | |
| Fore_p1.stl | 106.0KB | |
| Fore_p2.stl | 85.6KB | |
| Fore_Rail.stl | 75.5KB | |
| Receiver_F.stl | 98.7KB | |
| Reciever_Feed.stl | 61.1KB | |
| Reciver_B.stl | 77.6KB | |
| Scope_Full.stl | 142.9KB | |
| Scope_Rail.stl | 52.8KB | |
| Unfit_Autocannon_bullet.stl | 205.0KB | |
| Unfit_Autocannon_charging_handle.stl | 40.3KB | |
| Unfit_Autocannon_handle.stl | 46.4KB | |
| Unfit_Autocannon_handle_pin.stl | 38.2KB | |
| Unfit_Autocannon_handle_pin_cap.stl | 38.2KB |
