This is a 3d Printed Model Rocket with Helicopter return. Designed to run off of an 18mm engine. Open Rocket indicates that it will get close to 800ft on a C6-5 (I will update once I get final weights after assembly.
At the Recovery Device Deployment the motor tube and motor eject out the back and returns to earth on a streamer. The rocket tail-flaps will then flip over because they are held by rubber bands. This converts it into a helicopter for the main body return.
Fin.stl | 226.6KB | |
FinMount.stl | 345.5KB | |
FlapRetainer.stl | 70.4KB | |
nose.stl | 1.4MB | |
TailFlap.stl | 121.4KB |