Height Gauge & Marker For Pencils 3D Printer Model
The file 'Height Gauge & Marker For Pencils 3D Printer Model' is (stl) file type, size is 5.9MB.
The file 'Height Gauge & Marker For Pencils 3D Printer Model' is (stl) file type, size is 5.9MB.
Heyho
I make knife and for the handles I don´t want to use my heavy height ripper all the time.
So I designed this height marking device to use with a normal pencil.
There are two versions.
In addition to the printed parts and a standard sized pencil you will need one M5 screw. I used a M5 x 20 mm one. But shorter screws will work fine too!
I printed it with PLA, 3 Perimeters & 25% infill. But more certainly does no harm and make the system stiffer.
If you have problems with turning the knob use some paraffin (kandle) or another lubricant.
Have fun marking and keep on printin!
If you like my work, I would be very happy about a small tip :)
https://www.paypal.com/paypalme/MeisterEdel
Update 1: 25.11.2022
Added a Holder for a Carpenters pencil. (I dont have one lyin around so I cant test it myself) This holder will rise the lowest position a little bit.
Update 28.12.2022
Fixed the large height tower because the measurements were off a few mm! Sorry :)
| Height_Gauge_75_-_1045_mm_Tower.stl | 1.5MB | |
| Height_Gauge_75_-_1045_mm_Tower_Set.stl | 3.7MB | |
| Height_Gauge_75_-_65_mm_Set.stl | 4.0MB | |
| Height_Gauge_75_-_65_mm_Tower.stl | 1.7MB | |
| Height_Gauge_Carpenters_Pencil_Holder.stl | 2.0MB | |
| Height_Gauge_Knob.stl | 922.2KB | |
| Height_Gauge_Pencil_Holder.stl | 1.4MB | |
| Height_Gauge_Wedge.stl | 55.2KB |
