Height Gauge 3D Printer Model
The file 'Height Gauge 3D Printer Model' is (stl) file type, size is 525.5KB.
The file 'Height Gauge 3D Printer Model' is (stl) file type, size is 525.5KB.
This is a height gauge I wanted for my shop on the table saw and router table.
I made it so it can be calibrated before use. I took the time to lightly sand the top of the calibration flange to sharpen the points just a bit to increase the accuracy of the gauge.
The rule holder can either ride the tool or bit up to the desired height or you can set a height and lock it in using the rear knob.
I ran a 4mm tap into the locking knob hole so that it would screw in and out smoothly without any resistance.
I put 4mm holes in the rule holder and the feet of the gauge body for small magnets. The gauge also uses the following...
4 pcs. 4mm x 10mm cap screws for the calibration flange
4 pcs. 4mm flat washers for the calibration flange
1 pcs. 4mm x 30mm cap screw for the rear lock knob (use a touch of CA or tap the locking hole in the gauge body so that the knob will not spin freely on the screw)
1 pc Starrett 6" steel rule part number C303R-6
If you have any suggestions on how to improve this gauge please feel free to let me know otherwise enjoy and I hope it helps you in your own creative endeavors.
| 4mmKnob.stl | 1.7MB | |
| CalibrationFlange.stl | 70.4KB | |
| GaugeBody.stl | 235.8KB | |
| Rule_Holder.stl | 19.4KB |
