UPDATE! NEW 3D-Printer Temperature-Test-Tower TTT
Changed and uploaded: 25.07.2018
3D Printer Heating Testtower (175°C-250°C in 5°C Steps)
Dimensions: 50x20x50mm (10 Testlayers)/ 50x20x5mm (1 Testlayer)
Set temperature change every 5mm!
If you dont know whether your printbed has enough adhesion with lower temps, use the TTT which start with a high temp first.
IMPORTANT:
Please make shure, that your printer prints at 175°C if you're using a version with 175°C.
Otherwise change and use a setting with a higher temperature at the 175°C piece!
EXAMPLE & MANUAL:
At 0.2mm resolution (layer height) you will need following temperature layers (change every 25 layers):
Example: 205-250.stl
from 1: 205°C
from 26: 210°C
from 51: 215°C
from 76: 220°C
from 101: 225°C
from 126: 230°C
from 151: 235°C
from 176: 240°C
from 201: 245°C
from 226: 250°C
Please comment, if you need some improvements.
| 175.stl | 2.0MB | |
| 205.stl | 2.0MB | |
| 220.stl | 1.4MB | |
| 250.stl | 1.4MB | |
| single_175.stl | 180.4KB | |
| single_180.stl | 217.1KB | |
| single_185.stl | 213.3KB | |
| single_190.stl | 208.7KB | |
| single_195.stl | 204.9KB | |
| single_200.stl | 217.5KB | |
| single_205.stl | 213.4KB | |
| single_210.stl | 198.0KB | |
| single_215.stl | 193.9KB | |
| single_220.stl | 214.1KB | |
| single_225.stl | 210.0KB | |
| single_230.stl | 226.4KB | |
| single_235.stl | 222.2KB | |
| single_240.stl | 199.0KB | |
| single_245.stl | 194.9KB | |
| single_250.stl | 214.4KB |
