I made these eyes from the Thingiverse model called "Eye mechanics with all possible movements" by kakiemon, then added it to my created head. I used MG90S servos in the main control section but they don't fit the eyes, For them, you need to get Micro Servo SG90 servos, I think they would work and fit in the main servo controller board also, but I never had any more to try it.
https://youtu.be/j4iKKTsQd-0
https://www.youtube.com/watch?v=LCMhdRdwqf4
| 16_Ch_Servo_Controller_Mount.stl | 291.3KB | |
| Arduino_Board_Mount.stl | 289.7KB | |
| Back_of_Head.stl | 1.5MB | |
| Bottom_Left_Lid_Axle.stl | 175.7KB | |
| Bottom_Right_Lid_Axle.stl | 176.1KB | |
| Eye_Balls_Lever_Rod.stl | 80.8KB | |
| Eye_Ball_left.stl | 1.4MB | |
| Eye_Ball_right.stl | 1.4MB | |
| Eye_Holder.stl | 153.4KB | |
| Face.stl | 3.6MB | |
| Face_For_Testing.stl | 1.9MB | |
| Glasses.stl | 1.3MB | |
| Head_Face_and_Eyes.stl | 10.8MB | |
| Hinge_Frame.stl | 109.2KB | |
| Left_Eye_Lid_Lever_Bottom.stl | 64.7KB | |
| Left_Eye_Lid_Lever_Top.stl | 69.4KB | |
| Left_Lid_Bottom.stl | 295.3KB | |
| Left_Lid_Top.stl | 317.5KB | |
| Lid-Frame.stl | 501.1KB | |
| Nose_Root.stl | 413.2KB | |
| Right_Eye_Lid_Lever_Bottom.stl | 78.0KB | |
| Right_Eye_Lid_Lever_Top.stl | 64.7KB | |
| Right_Lid_Bottom.stl | 317.8KB | |
| Right_Lid_Top.stl | 295.5KB | |
| Servo_Base.stl | 376.8KB | |
| Servo_Base_Mount_Bracket_1.stl | 37.1KB | |
| Servo_Base_Mount_Bracket_2.stl | 37.3KB | |
| Servo_Lever_1_Rod.stl | 55.2KB | |
| Servo_Lever_2_Rod.stl | 55.0KB | |
| Servo_Lever_3_Rod.stl | 55.2KB | |
| Servo_Lever_4_Rod.stl | 55.2KB | |
| sketch_Puppet.ino | 29.5KB | |
| Top_Left_Lid_Axle.stl | 175.4KB | |
| Top_Right_Lid_Axle.stl | 176.1KB |
