This was put together quickly for a short notice favorite-book-character costume party.
After using MeshMixer to make the base model look more like what I wanted, I used Slic3r to split the top end in half so it was easier to print laying down. I left the bottom half as a single piece.
As I printed the top prints in half, I glued the top pieces together with superglue. The handle shown in the picture broke away from the print bed when it was almost done, so it's actually a little shorter. I probably should have used a brim. I drilled a hole where the two parts meet and used a short length of dowel to hold them together. I added a little black Gorilla tape to the bottom to cover up the bit of infill that was showing. Otherwise this is unfinished.
| harry-potter-wand-split-2.stl |
| harry-potter-wand-split.stl |
