This is a caddy for HP workstations Z600, Z620, Z800, XW6600, XW8600 or anything that has at least 2x5.25 spaces open. The caddy can be secured with the built-in latch, but it is a tight enough fit to secure itself by friction alone.
It can house 2x3.5+3x2.5 drives. 2 of the 2.5 drives can be SSD or HDD with 7-13.5mm thickness. The 3rd one will fit a 7mm SSD only.
+++++++++++++
I uploaded a raid version that will allow you to use additional 2.5 drives instead of the 3.5 ones or in any valid combination (9 x 2.5 drives or 5 x 2.5 drives + 2 x 3.5). If you don't use 3.5 drives at all, you have to use the 1-inch spacers to keep the original dimensions. You can get commercial brass M3 spacers or use 8xM3 nuts. I included a design here too that you can print as many times as needed. Use 30mm M3 screws inside the spacers.
| front+raid.stl | 163.9KB | |
| front.stl | 163.9KB | |
| left+raid.stl | 380.1KB | |
| left.stl | 70.2KB | |
| middle+raid.stl | 197.2KB | |
| middle.stl | 68.1KB | |
| right+raid.stl | 197.3KB | |
| right.stl | 258.2KB | |
| spacer+raid.stl | 80.9KB |
