no drier box dispenses from bottom so i made this to hang above my encloser. i use direct drive have a 12 inch bowen tube down to inside of my encloser and it spools out great... use the back and lid to help keep dry... for the lid i used clear vynl that is double edge tape to hold it on and also taped the back on..i used 12mm bearings for the rollers... i had bearing and posts out of burnt out filament drier that i reused in this.. get some 12mm od bearings and aluminum rod to go in between and bam it rolls.. back is thinner..didnt need it for support just to seal it up... i used magnetic tape on the face and lid to hold it in place.. i had some pcs i trimmed off my magnetic build plate left over and it flexed around the inner lid just fine..
| back.stl | 106.7KB | |
| body.stl | 380.4KB | |
| lid.stl | 165.3KB |
