30.09.24 - handy clip on for vac-u-lock and suction based dildos

This is part of making the handy more of a universal joy toy for men and women.

Nogro made something similar a few years ago -

https://www.thingiverse.com/thing:5253681/files that was based on some of my old adapter ideas for the thrusters back then -

https://www.thingiverse.com/thing:5076803

I remixed the vac-u-lock part from www.thingiverse.com/thing:4882055 and checked others to confirm the rough sizing.

It's 2-in-1 to hold vac-u-lock and suction cup based dildos - I think ideally for vaginal use as I am unsure if the handy motor or motors if two are used, could be damaged from resistance if not lubed up enough etc.

To print this, either print the mjf pa12 version as named, in pa12 by mjf printing,

or if going fdm, print with petg, 0.12 layer height for added density strength or 0.2 standard should be fine, infill 25% to more. Print part a and part b and 9 connector dowel pegs. Press the pegs into one part then press the other part together. Depending on print tolerances, it should fit perfectly but may require some super glue for added hold.

You could print the vertical piece in fdm too but due to the print orientation along the z axis, just like if you printed a pen upright, it could snap along a layer line. If print at 0.12 layer height, it might be a bit stronger and holder together better - Also, use 25% + infill.

• Bear in mind the hand motor can take only upto 500 grams - You could mount 2 handys with 2 hands3 prints - maybe just nut and bolt them down to make a his-smith sort of toy at a lower price. You will need to sync 2 handys to one controller or you and the controller could both use say multiple tabs so that you can give both handy keys and the controller can say open up 2 ayva remote tabs, maybe in different browsers, and then their control movement will sync to both the handys.

For this control of the handy or handys, you can use xtoys, ayva remote and you could look into a really cool project from botcrusher that uses a sensor that detects movement distances that can be synced to handy movements - Check out

https://discuss.eroscripts.com/t/the-inchworm-new-device-part-2/186490

Good luck with your prints - Please do feedback here or in the Handy Discord.

Enjoy