Hello I made this for my Russian dwarf hamsters, the goal was to have a nice wheel that is almost silent, it prints in 3 main parts and prints well. The back with back down, wheel with its back down but support on for small flange in centre and the front front down. I used abs but pla should be even easier.
It needs 2x 608 bearings, get industrial if you can not cheep skateboard ones as they are noisy after a while! also a 8mm bolt and nut, preferably washers and a lock nut but not necessary. thanks have a wheely good time!
| hamster_WHEEL.stl | 11.9MB | |
| hamster_wheel_BACK.stl | 1.3MB | |
| hamster_wheel_FRONT.stl | 526.6KB | |
| hamster_wheel_spacer.stl | 787.3KB |
