I made a 3d printed version of the toilet paper roll glowstick eyes.
UPDATED moved the holes to the top for hanging from the light string
I resized this: https://www.thingiverse.com/thing:468917
And added these: https://www.thingiverse.com/thing:514043 and https://www.thingiverse.com/thing:732437
Then added some holes and a slot for the wire.
The idea is to take a string of LED Xmas lights and put them inside the holes. I made the cutout so you can insert them wire first, then pull them tight. They tend to be a tad bit loose, and this was on purpose cause I wanted to be able to remove them and reuse the lights.
Tape off the unwanted lights, and all you see is the glowing.
Printed in 2 pieces so the sliding lid can be colored a different color than the box. Yellow, white, Red, etc.
Enjoy!
| Eyebox_hang_1.stl | 8.2MB | |
| Eyebox_hang_2.stl | 9.5MB | |
| Eyebox_hang_3.stl | 10.0MB | |
| Eyebox_set_1final.stl | 9.0MB | |
| Eyebox_set_2final.stl | 10.2MB | |
| Eyebox_set_4final.stl | 8.5MB | |
| eye_lid.stl | 22.5KB |
