I wanted to run a LED in each eye with a 9v battery and a switch to beable to turn it on and off. So I did some editing in Fusion 360 and came up with this. There is a hole running from each eye to a central point and then runs down through the body connects to the battery compartment and then to the switch. The eyes now fit a 5mm LED. The battery compartment cover can be secured on with 4mm screws. I would not recommend scaling this since the holes are precise. Happy printing!
LEDs
https://www.amazon.com/dp/B07T8H5D64?psc=1&ref=ppx_yo2_dt_b_product_details
Switch
https://www.amazon.com/dp/B07S2QJKTX?psc=1&ref=ppx_yo2_dt_b_product_details
9v connector
https://www.amazon.com/dp/B08SL9X2YC?psc=1&ref=ppx_yo2_dt_b_product_details
| crowFeet.stl | 3.4MB | |
| CrowHeadLED.stl | 768.8KB | |
| crowTail.stl | 6.9MB | |
| Crow_Belly_Battery_cover.stl | 41.0KB | |
| Crow_body_with_hole.stl | 734.6KB |
