A holeless knuckle duster. Inspired by the NickNuk Pow! and Elder Futhark's Hammerhead knucks. Made in Sketchup. A flat edge version was used for easier editing. The final version was rounded with fredo6's RoundCorner plugin.
I went through several iterations for a good feel. It's still small compared to full dusters and may slip in the hand. Thickness of 10mm-15mm felt best. The finger notches are oval, not completely round, to provide room for the fingers.
Test versions printed on a CEL RBX01 in ABS 40% infill.
| halfsies_knuckle_duster_-_final.skp | 1.3MB | |
| halfsies_knuckle_duster_-_final.stl | 103.9KB | |
| halfsies_knuckle_duster_sharp_corners.skp | 1.1MB | |
| halfsies_knuckle_duster_sharp_corners.stl | 12.3KB |
