H60 Tail Landing Gear Teflon Coated Washer Clamp 3D Printer Model
The file 'H60 Tail Landing Gear Teflon Coated Washer Clamp 3D Printer Model' is (stl) file type, size is 39.6KB.
The file 'H60 Tail Landing Gear Teflon Coated Washer Clamp 3D Printer Model' is (stl) file type, size is 39.6KB.
1/2" hole in the center for all-thread to tighten clamp. I used nut job scad file (https://www.thingiverse.com/thing:193647) to make wing nuts to prevent over tightening. The photo only has a clamp on the bottom for test fitting, I would recommend printing two, one for upper and lower.
| yoke_tef_washer.stl | 150.1KB |
