as-built version of the long demag torpedos as they were delivered to hainaut-sambre.
I had very little information about this version, so it;s just eyeballed from 1 low-res factory photo you see here. Some details can be clearly seen, such as the boxier houses, brakeman's cab, heat shields on the inner bogies and more basic brake controls.
I suspect there's some detail missing around the ladle hole, if you have more information please let me know.
If you want to build the later version of these long torpedos, just take the 3 ladle parts from this design and stick them in the short demag: https://www.thingiverse.com/thing:6501558
assembly is basically the same as the other demag mentioned above, so look at the instructions there and if there are any questions let me know. The only real differences are a longer ladle and a brakeman's cab, which is 1 piece so should not pose a lot of trouble. (I'd print the brakeman's cab upside down btw)
I hope it goes together well, I haven't printed or built it yet so please let me know how you're doing with it!
These cars didn't go onto the main line and didn't have a lot of lettering on them. Colour scheme see demag factory picture:
bright silver: ladle (well that obviously didn;t last long)
medium grey: chassis, buffers, houses, brakeman's cab
black: bogies, lettering on ladle
red: brake controls, brake pipe in brakeman's cab, flexible air hose from chassis to ladle, ladle indicator arrows
posting a make when you build this model would be appreciated!
| bogie_carrier_demag_2x.stl | 381.2KB | |
| bogie_demag_3x.stl | 11.7MB | |
| bogie_demag_w_hand_brake_1x.stl | 11.9MB | |
| bogie_demag_w_heat_shield_2x.stl | 11.7MB | |
| brakemans_cab_1x.stl | 1.4MB | |
| buffer_demag_4x.stl | 652.3KB | |
| chassis_demag_original_motor_end_1x.stl | 2.4MB | |
| chassis_demag_original_roller_end_1x.stl | 2.4MB | |
| hand_brake_wheel_demag_2x.stl | 496.3KB | |
| house_motor_end_demag_original_1x.stl | 3.4MB | |
| house_roller_end_demag_original_1x.stl | 3.8MB | |
| ladle_long_mid_1x.stl | 2.3MB | |
| ladle_long_motor_end_1x.stl | 1.7MB | |
| ladle_long_roller_end_1x.stl | 1.5MB | |
| nem_pocket_demag_2x.stl | 34.8KB | |
| step_demag_4x.stl | 157.5KB | |
| torpedo_house_motor_end_type_1_extra_bit_1x.stl | 79.3KB | |
| torpedo_ladle_end_2x.stl | 221.7KB | |
| torpedo_ladle_position_arrow_2x.stl | 14.1KB | |
| torpedo_ladle_support_motor_end_cover_type_1_1x.stl | 92.2KB | |
| torpedo_ladle_support_motor_end_type_1_1x.stl | 1.6MB | |
| torpedo_ladle_support_roller_end_1x.stl | 2.9MB |
