There are two versions: a hand-held fidget toy and a motorized desk toy.
The hand-held toy is 100% 3d-printed and slots in and out of the motorized base with ease.
Check it out at https://www.youtube.com/shorts/WkCqcTuz9W0
There are different versions of the inner-most axle. There is a minion (https://www.thingiverse.com/thing:403110), a humming bird (https://www.thingiverse.com/thing:3307572), or a blank axle. Using the blank axle, you can put any model you wish inside! Note that if the minion and bird models I used print poorly, it is because I needed to scale them down a lot.
For the handheld version, you need to print 4 'color1-clip's and 1 of everything else (without base in the title). For the motorized version, you will also need to print 2 'base-arm's, 1 'base', and 1 'base-Spur gear'. You will also need a battery holder (https://www.amazon.com/dp/B0CSFFDN56?ref=ppx_yo2ov_dt_b_fed_asin_title), batteries, a motor (https://www.amazon.com/dp/B00GYRSDSE?ref=ppx_yo2ov_dt_b_fed_asin_title), and solder and a soldering iron.
Some parts may need to be sanded to run smoothly.
| base.stl | 239.2KB | |
| base_-_arm.stl | 8.1KB | |
| base_-_Spur_gear.stl | 76.0KB | |
| color1-clip.stl | 1.4KB | |
| color1-drivinggear.stl | 117.2KB | |
| color1-ring.stl | 38.6KB | |
| color2-drivinggear.stl | 104.1KB | |
| color2-ring.stl | 41.5KB | |
| color2-spur_gear.stl | 88.4KB | |
| color3-drivengear.stl | 99.0KB | |
| color3-drivinggear.stl | 104.9KB | |
| color3-ring.stl | 37.7KB | |
| color4-drivengear.stl | 78.2KB | |
| color4-ring.stl | 38.8KB | |
| color5-axle.stl | 16.3KB | |
| color5-axle_with_bird.stl | 56.0MB | |
| color5-axle_with_minion.stl | 5.9MB | |
| color5-gear.stl | 79.0KB |
