GVT First Class Coach 3D Printer Model
The file 'GVT First Class Coach 3D Printer Model' is (stl) file type, size is 1.7MB.
The file 'GVT First Class Coach 3D Printer Model' is (stl) file type, size is 1.7MB.
For this coach I have completely redrawn the sides from scratch and used some of the files by GE_Rik in the construction of the second class coach and used the outline of the seats by Caderifor which were rather too angular when I printed them so these were also redrawn to suit. The roof has the rain strips as per my Guards van,
In essence the coach is the same as the second class coach only with nicer seating but it was still enough for me to want to create a specific model for it.
The model as shown is almost complete, all that is needed is the GVT crest from Endon Valley Decals, a coat of lacquer, and windows and couplings to complete.
If you have seen my guards van then all post printing and assembly information is the same.
There is also a NEM pocket holder that is a press fit between the bars of the chassis and a push fit for a standard NEM pocket which permits the fitting of the Bachmann chopper couplings for those who have any of the NG7 locos from Bachmann.
| First_class_back_to_back_seats.stl | 63.8KB | |
| First_class_seating.stl | 46.6KB | |
| GVT_1892_coach_chassis2.stl | 2.5MB | |
| GVT_1892_coach_end_w_brake.stl | 725.1KB | |
| GVT_1892_coach_end_w_steps.stl | 360.8KB | |
| GVT_1892_coach_floor.stl | 999.4KB | |
| GVT_1892_coach_roof_vent-2.stl | 92.8KB | |
| GVT_1892_coach_steps.stl | 133.7KB | |
| GVT_coach_roof_V10.stl | 223.3KB | |
| GVT_coach_side_1st_class_Redrawn_v1.stl | 586.4KB | |
| NEM_coach_pockets.stl | 3.6KB |
