Guitar Stand 3D Printer Model
The file 'Guitar Stand 3D Printer Model' is (stl,f3d) file type, size is 1.2MB.
The file 'Guitar Stand 3D Printer Model' is (stl,f3d) file type, size is 1.2MB.
Easy to print guitar stand for acoustic and electric guitars. This was modeled roughly after my Amzn Basics stand after not being able to find a printable stand online that I liked. I designed it to be easily printable without supports. Add neoprene or soft material to areas that come into contact with guitar for addl protection.
Tolerances between joints is 0.15mm, which worked well for my printer. If this is too small in general please let me know and I will update the design with larger tolerances.
| ALL_PARTS.stl | 304.8KB | |
| center_brace_support_beam_2x.stl | 684.0B | |
| center_brace_support_beam_connector.stl | 1.6KB | |
| center_brace_to_leg_connector_left.stl | 2.8KB | |
| center_brace_to_leg_connector_right.stl | 2.8KB | |
| connector_a_frame_left.stl | 4.0KB | |
| connector_a_frame_right.stl | 4.0KB | |
| connector_base_left.stl | 5.6KB | |
| connector_base_right.stl | 5.6KB | |
| connector_cap_rear_2x.stl | 1.1KB | |
| connector_left_cap_front.stl | 2.6KB | |
| connector_right_cap_front.stl | 2.6KB | |
| connector_top.stl | 28.0KB | |
| frame_base_front_2x.stl | 1.3KB | |
| frame_base_rear_2x.stl | 1.3KB | |
| frame_lower_a_2x.stl | 1.3KB | |
| frame_upper_a_2x.stl | 1.3KB | |
| guitar_holder_left.stl | 116.8KB | |
| guitar_holder_right.stl | 116.8KB | |
| Guitar_Stand.f3d | 1010.4KB |
