Guitar Hero Warriors Of Rock Custom Wings V3 – WoRlock 3D Printer Model
The file 'Guitar Hero Warriors Of Rock Custom Wings V3 – WoRlock 3D Printer Model' is (stl) file type, size is 787.8KB.
The file 'Guitar Hero Warriors Of Rock Custom Wings V3 – WoRlock 3D Printer Model' is (stl) file type, size is 787.8KB.
UPDATED 8-7-24
Completely resized the left side to address silhouette concerns.
UPDATED 7-8-24 @ 7:45pm
Updated pegs for the Mini connectors for better fitment
These are based off the BC Rich Warlock, and by extension the BC Rich Warbeast controller!
If you have a large enough printer to support it, use the "Whole" variant.
If you have a small printer, each of the "Mini" variants fit comfortably onto the bed of a Bambu Lab A1 Mini, and are then attached together.
For a Big Printer, download:
GHWOR-WoRlock-L-Whole.stl
GHWOR-WoRlock-R-Whole.stl
For a small printer, download:
WoRlock-ALL-MINI-Pieces.zip
OR
GHWOR-WoRlock-L-Mini-Top.stl
GHWOR-WoRlock-L-Mini-UpMid.stl
GHWOR-WoRlock-L-Mini-Middle.stl
GHWOR-WoRlock-L-Mini-Bottom.stl
GHWOR-WoRlock-R-Mini-Top.stl
GHWOR-WoRlock-R-Mini-Middle.stl
GHWOR-WoRlock-R-Mini-Bottom.stl
and 10 of:
GHWOR-PreWoRder-Mini-Connector-YOU-NEED-10-OF-THESE.stl
Note for mini users, the connectors SHOULD pressure-fit, but backing it up with an adhesive may give more reliable results!
| GHWoR-Mini-Connector-YOU-NEED-10-OF-THESE.stl | 3.8KB | |
| GHWOR-WoRlock-L-Mini-Bottom.stl | 34.4KB | |
| GHWOR-WoRlock-L-Mini-LowMiddle.stl | 54.3KB | |
| GHWOR-WoRlock-L-Mini-Top.stl | 312.3KB | |
| GHWOR-WoRlock-L-Mini-UpperMiddle.stl | 343.1KB | |
| GHWOR-WoRlock-L-Whole.stl | 691.5KB | |
| GHWOR-WoRlock-R-Mini-Bottom.stl | 40.7KB | |
| GHWOR-WoRlock-R-Mini-Middle.stl | 310.3KB | |
| GHWOR-WoRlock-R-Mini-Top.stl | 375.1KB | |
| GHWOR-WoRlock-R-Whole.stl | 726.0KB |
