Guitar Amp Jack Socket Blocker 3D Printer Model
The file 'Guitar Amp Jack Socket Blocker 3D Printer Model' is (stl) file type, size is 973.6KB.
The file 'Guitar Amp Jack Socket Blocker 3D Printer Model' is (stl) file type, size is 973.6KB.
This Thing is a small tapered plastic blocker for 6.35mm (1.4") jack sockets, commonly found on the back of guitar amplifiers.
When gigging with my guitar amp I noticed that occasionally I'd connect the footswitch jack plug into the wrong socket, which would cause some odd noises until I could work out what I'd done. On some amplifiers, connecting to the wrong socket could easily cause damage to the amplifier or to whatever you connected to it.
Initially I just covered up all the other sockets with duct tape, but after a while I wanted a better looking solution, so I designed a blocker plug which blanks off the socket.
These are designed with a taper, but the exact internal dimensions of 1/4" sockets varies quite a lot, so to achieve the perfect fit, I recommend wrapping a single layer of electrical tape around the plug, which provides a good fit and stops the blocker falling out.
| jack-socket-blocker.stl | 2.8MB |
