I designed this dash mount for a Grom, as we had to remove the headlight stay to make room for an auxiliary fuel tank as this bike is used in endurance racing.
Installs on ProTaper handlebar brace/cross bar where your bar pad goes (bar diameter of 12.65-12.7mm). This does NOT clamp to the actual handlebar itself and you will need to remove your bar pad. Confirmed to fit on a 2018 Grom.
Install the 6 screws loosely to clamp the mount to the bar, then install the 3 screws into the back of the dash (tighten fully). Position the dash at the angle you want and center it on the bar, then use an Allen key from the bottom to tighten all 6 M3 screws (do not overtighten, just tighten until there is no more gap between the two pieces).
| Grom_Dash_Mount_v2.stl | 884.5KB |
![Honda Civic EK9 [G8D-240H-A] Remote Control Keyfob 3D Printer Model](https://cdn.3axis.co/assets/2d/07/da/6b/2d07da6b-6a62-4e3c-aba6-bf360939053f/images/56164047-4cd2-49e6-a559-d6551513000c_thumb.jpg)
