Grease Gun Holder 3D Printer Model
The file 'Grease Gun Holder 3D Printer Model' is (stl,FCStd) file type, size is 3.0MB.
The file 'Grease Gun Holder 3D Printer Model' is (stl,FCStd) file type, size is 3.0MB.
Grease gun clip holder, will fit any "standard" grease gun with ~57mm OD, including this Napa model. I have two different grease guns (one for moly grease chassis the other for red wheel bearing grease) and they both fit. The moly gun is from the 1970s, which makes me think this 57mm OD is somewhat standardized to fit typical North American grease tubes.
Holder has 2 recessed screw pockets and thru holes. Can attach to any flat surface. Top to bottom is 90mm - i.e. same as the "4 inch" side of a typical N.A. "2x4". Width is narrower than the "2 inch" side of a 2x4. Clip securely holds gun in place.
Also included a nozzle holder which clips to the handle of the Napa gun. This likely won't fit other guns, but could be modified to suit. Nozzle holder has a small recessed pocket to catch errant drips. A window is cut from the side so you can swipe a rag to clean up the mess.
Further, there's a bottom cap which can snap on to catch any errant drips from the piston.
| Bottom_cap_Meshed.stl | 168.7KB | |
| GreaseGunClip_Meshed.stl | 250.0KB | |
| grease_gun_holder.FCStd | 682.0KB | |
| NapaHoseClip_Meshed.stl | 5.1MB |
