Grasshopper Drone 3D Printer Model
The file 'Grasshopper Drone 3D Printer Model' is (stl) file type, size is 475.0KB.
The file 'Grasshopper Drone 3D Printer Model' is (stl) file type, size is 475.0KB.
My second attempt at a DIY drone from scratch.
Printed in Fluorescent yellow pla.
Use support to buildplate for GPS and body.
Weighs 1274g, so not light, but the motors can take it.
I may change the legs as they give a hard landing.
Parts list:
PLA fluorescent yellow - £9.99 ebay
Kakute F4 v2 AIO - £32 banggood
920 kv 2212 motors x 4 £17 amazon
ESC 20A x 4 - £20 banggood
Flysky rxtx fs-i6s fs-1a10b
Props 1045 dji shaft x 4 £5 banggood
Skyzone FPV kit - £250 gearbest
3300mah 3s lipo - (was £19) £28 Amazon (https://www.amazon.co.uk/gp/product/B0113JGZ1O/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1)
GPS betian 880 with mag - £13 Banggood
Lipo charger - £5 banggood
Aomway antenna 5.8ghz x 2 - £10 banggood
8 x m3x30mm screws
12 x m3 locknuts
4 x m3x10mm screws
4 x m3x5mm screws
40mm fan and heatsink - fan was stolen from my anet a8 extruder, heatsink was found in an old amplifier.
Sticky felt pads.
Cable ties.
INAV software.
Foam for underneath the FC to dampen the barometric sensor.
FC is hard mounted as gyro is on foam. The fan and heatsink are to keep the vtx cool.
Run a 3.2mm drill on reverse through the top arm holes in body, 3.5mm in arm to body holes.
Use felt pads to pack in the stereo camera.
Questions welcome
| Grasshopper_Arms.stl | 1.0MB | |
| Grasshopper_Body.stl | 462.6KB | |
| Grasshopper_GPS.stl | 176.7KB | |
| Grasshopper_Legs.stl | 251.5KB |
