Grappling Hook – Uncharted 4 *Remix* 3D Printer Model
The file 'Grappling Hook – Uncharted 4 *Remix* 3D Printer Model' is (stl) file type, size is 716.16 KB.
The file 'Grappling Hook – Uncharted 4 *Remix* 3D Printer Model' is (stl) file type, size is 716.16 KB.
This is a Remix of : Grappling Hook - Unchaterd 4 by That3DPrintGuy
Only minor tweaks and scale set for easier printing, all design credit to That3DPrintGuy for a great moving model that looks awesome !!!!
Be careful when gluing the "Upper-Shaft" and "Lower-Shaft" together, the centre join is offset, and the grappling arms need to line up with the holes in the "Lower-Shaft" so suggest attaching the arms, before gluing !
You will need to print 3 x "Arm" and 3 x "Pin_and_Cap"
The "Top_Screw_Spacer" is optional, you can use this if your "Top_Screw" does not go down far enough.
Updates to original models as follows:
1) Scale,
I used a scale of 5:1 from the original size loaded in my Slicer - this is still more child sized than "Man-Sized".
2) A few pieces have been scaled to allow for bigger tolerances, the "pins" and "top screw", as they were too tight for me in the original models.
3) Arm - Remove the bulge from the "teeth" on underside for a flatter print surface.
4) Added some angles to the "Upper-Shaft" and "Lower-Shaft" for easier printing of some over hangs or bridges. Very minor tweak to originals.
I've uploaded image raw, straight from the printer , just glued where required, will look to do a proper filler and paint job and post results.
I scaled the parts using Repetier (My Slicer Software), and then exported them as .STL files, I hope these work for you. They looked OK in Windows 3D Builder too.
| Grap-Arm.stl |
| Grap-Base-Ring.stl |
| Grap-Lower_Shaft.stl |
| Grap-Pin_and_Cap.stl |
| Grap-Top_Screw.stl |
| Grap-Top_Screw_Spacer.stl |
| Grap-Upper_Shaft.stl |
