Graphics Card Stand Saiyan Power Up 3D Printer Model
The file 'Graphics Card Stand Saiyan Power Up 3D Printer Model' is (STL) file type, size is 389.6KB.
The file 'Graphics Card Stand Saiyan Power Up 3D Printer Model' is (STL) file type, size is 389.6KB.
I needed a new graphics card stand when I got a new card. I was using a Goku figurine to hold up the old one, but he wouldn't fit with the new one and I still wanted to use him. So I came up with this. I tried printing it in white, but it did too good of a job blocking the leds. I found clear to be a very good diffuser.
Lights Inward Track Style- The lights point inward, and you have to feed the lights through. I do not recommend this version.
Lights Outward Track Style - This version has the lights pointing outward. If you have a really well tuned printer, this is the cleanest version. WARNING: Globs, stringing, etc from a less than optimal print may hamper your ability to print this.
Stand V3 Cut Bottom V2 - I cut the part in two to make the print easier and to ensure the lights could be put in. It has one tip cut off to make a platform to rest the card on.
Stand V3 Cut Top - The other half
Stand V4 Cut Bottom - Same as V3, but with a larger cut out for the card
Stand V4 Cut Tom - The other half
| Graphics_card_stand_Lights_Inward_Track_Style.STL | 283.9KB | |
| Graphics_card_stand_Lights_outward_Track_Style.STL | 295.4KB | |
| Stand_v3_Cut_Bottom.STL | 227.5KB | |
| Stand_v3_Cut_Bottom_V2.STL | 256.3KB | |
| Stand_v3_Cut_Top.STL | 169.9KB | |
| Stand_v4_Cut_Bottom.STL | 244.6KB | |
| Stand_v4_Cut_Top.STL | 158.1KB |
