I designed this cover to protect the Igniter for transport or just to keep it from getting damaged.
Please note the fitment is quite tight when locking it into place at first, it will ease up after a little after its been on and off a few times, i wanted it to be a tight fit and the two ive printed so far work perfectly fine and lock into place.
Edit: Added a V2 version that is 4mm taller, the older version was quite close on the clearance, and if you didn't use supports then the sag could hit the top of the igniter, the V2 version should be better all round, id recommend supports anyway.
| Roccbox_Gas_Igniter_Cover.stl | 1009.9KB | |
| Roccbox_Igniter_Cover_V2.stl | 1005.5KB |
