This is for boosting up a Govee Lightbar from the Govee TV Lightbar/Light Strip/Camera set.
By default, it boosts it up by 100mm, and there are options for a flat body, angled 10deg body, or a 20deg one. Feel free to adjust the height of it in FreeCad, but you may want to make the base a bit bigger so it does not fall.
I am using this to illuminate my prints during a timelapse as I do not have any other use for the lightbars.
Feel free to leave any suggestions in the comments. I am relatively new to 3D design and would like some constructive criticism on this model :)
| GoveeLightbarExtender-Body-10deg.3mf | 182.4KB | |
| GoveeLightbarExtender-Body-10deg.stl | 848.0KB | |
| GoveeLightbarExtender-Body-20deg.3mf | 182.5KB | |
| GoveeLightbarExtender-Body-20deg.stl | 848.6KB | |
| GoveeLightbarExtender-Body-Flat.3mf | 181.7KB | |
| GoveeLightbarExtender-Body-Flat.stl | 846.9KB | |
| GoveeLightbarExtender10deg.FCStd | 38.9KB | |
| GoveeLightbarExtender20deg.FCStd | 44.5KB | |
| GoveeLightbarExtenderFlat.FCStd | 32.0KB | |
| GoveeLightbarExtenderPlate-Body.3mf | 93.3KB | |
| GoveeLightbarExtenderPlate-Body.stl | 442.9KB | |
| GoveeLightbarExtenderPlate.FCStd | 15.8KB |
