Made this GoPro mount / riser for a friends long board, but then also decided to make an adapter to mount a bike light I ordered for riding at night. The riser seperates the board and the truck 5mm (pictured is 7mm, this was overkill for supporting a GoPro, and my truck bolts didn't skrew all the way on with the original hardware, so I changed it). For the mount I used M5 hardware which should be the same as GoPro's use. I highly recoment printing this in ABS or nylon, because of the vibration from the board.
The bike light I used: https://www.fasttech.com/products/3916400 , You will need to use locktite on the skrew for attaching the light and the light mount. This thing is supper bright and uses a USB for power, so you can use it with any power bank, or 2A USB output!
Note: Some of the tollerances were a bit tight in my test model, so I ajusted the model before I uplaoded it, and they should be good now.
Note: I haven't had the chance to test it with a GoPro yet, so far just my flashlight, but I think it should work. - I will update this once my friend tests it with his GoPro
| goprolightmt2.stl | 1.3MB | |
| goproriser2.stp | 384.4KB | |
| goproriser4.stl | 4.8MB |
