parts you'll need
-gopro tripod mount (you can find one here on thingiverse)
-Four skateboard bearings
-one 5mm hex bolt for camera mount
-two small wood screws
-three 8mm x 80mm long bolts
-four washers as spacers for bearings
-five 4mm x 40mm long machine screws with locknuts for each weight or you could acetone weld the two halves together.
-files marked with *FF to be printed with flexible filament.
optional
add spring as seen in picture to dampen movement.
| session_gimble_-_base_pad_FF.stl | 78.4KB | |
| session_gimble_-_clip_to_gimble_joint.stl | 662.6KB | |
| session_gimble_-_cointop_FF.stl | 718.4KB | |
| session_gimble_-_handle.stl | 1.9MB | |
| session_gimble_-_hilt_fork.stl | 401.6KB | |
| session_gimble_-_pommel.stl | 659.4KB | |
| session_gimble_-_stem_Fork.stl | 735.0KB | |
| session_gimble_-_weight_Bottom.stl | 1.9MB | |
| session_gimble_-_weight_stem_A.stl | 487.0KB | |
| session_gimble_-_weight_stem_B.stl | 155.7KB | |
| session_gimble_-_weight_Top.stl | 1.9MB | |
| session_gimble_-_weight_Top_with_coinSlot.stl | 1.9MB |
