Goofy Pumpkin 3D Printer Model
The file 'Goofy Pumpkin 3D Printer Model' is (stl) file type, size is 13.9MB.
The file 'Goofy Pumpkin 3D Printer Model' is (stl) file type, size is 13.9MB.
A hollow pumpkin I designed with a goofy face on it. I used a small section of a white 12V LED strip on the top then glued the two pieces together. There is a small hole in the rear of the base to allow you to run a cable out of the back.
Note: The small arrow in the bottom of the top piece points toward the crease in the face.
| Jack-o-lantern_Bottom.stl | 10.1MB | |
| Jack-o-lantern_Bottom_V2.stl | 10.1MB | |
| Jack-o-lantern_Top.stl | 5.2MB | |
| Jack-o-lantern_Top_V2.stl | 5.2MB |
