Goodman For Sofirn SD01 Dive Torch 3D Printer Model
The file 'Goodman For Sofirn SD01 Dive Torch 3D Printer Model' is (stl) file type, size is 298.0KB.
The file 'Goodman For Sofirn SD01 Dive Torch 3D Printer Model' is (stl) file type, size is 298.0KB.
Goal is to print a goodman handle for an inexpensive Sofirn SD01 dive torch that puts center mass directly over the handle. It is a heavy torch and a bit awkward to mount on a retail goodman, especially with the rotating magnetic switch that requires some clearance to operate. This one was sized for my hand width in dry gloves and 5/16-8 hardware so a highland delrin speed nut can be used for adjustment, but feel free to remix to your hearts content for your own needs if this looks like a good place to start.
Only hardware required other than the two prints are:
5/16-18 x 1.5" Stainless flat head cap screw
5/16-18 stainless nylon lock nut
5/16-18 delrin speed nut
some 4mm bungie and a stainless bolt snap
| Goodman_for_Sofrin_SD01_handle.stl | 122.0KB | |
| Goodman_for_Sofrin_SD01_mount.stl | 669.2KB |
