This is a simple dish for pouring a bit of rubber cement, and mixing in some solvent to bring it to the desired thickness.
It's always good practice to mix out a little bit of glue into a dish for the garment you're working on. Your brushes / tools can make contact with glue in the dish, and not contaminate your fresh pots of glue or solvent. You can keep those precious pots closed too so they don't dry up.
Printing these at 10% infill with PLA should be fine. You can hand wash the dish when done, or just wait for the rubber cement to dry and just peel it out.
| Glue_dish_v1.skp | 96.7KB | |
| Glue_dish_v1.stl | 38.9KB |
