Gloomhaven Tree With Leaves 3D Printer Model
The file 'Gloomhaven Tree With Leaves 3D Printer Model' is (stl) file type, size is 18.2MB.
The file 'Gloomhaven Tree With Leaves 3D Printer Model' is (stl) file type, size is 18.2MB.
This is a new 3 Hex Gloomhaven Tree to replace the existing overlay tiles (3). Since my bushes worked well, I decided to try the same treatment on a tree, which was even harder to print. I've got it worked out pretty well (although it needs a lot of support), so I'm sharing it now (I'm printing my third one as I type this). I uploaded the whole tree, as well as a version that's cut and keyed for easier printing (the key is very forgiving). I also uploaded my supported version of the top, which is designed for a 1 mm layer height and a .4 mm nozzle. Smaller nozzles should work fine, but you could use a smaller support interface to make it easier to remove.
It's not easy to remove the support material. Just go at it with patience, removing 1 cm at a time, snipping the bits that are easy to get at as you work your way in towards the middle. I printed it with a brim on the top half, to give the support trees as much stability as possible (so the whole thing has a single big footprint).
If you want more details about the tree and how I got it printed, check out my blog post at http://objectforge.blogspot.com/2018/07/new-thing-trees-for-gloomhaven.html
| Tree-wLeaves-Bottom-JL.stl | 1.9MB | |
| Tree-wLeaves-Bottom.stl | 1.4MB | |
| Tree-wLeaves-Top-Supported2.stl | 46.6MB | |
| Tree-wLeaves-Top.stl | 7.3MB | |
| Tree-wLeaves3.stl | 8.5MB |
