Mesh board specification
It is a Glock 17(gen4) stand that can be mounted on a checkerboard mesh board made of 3mm thick wire.
Check that the mesh spacing is 50x50 mm and print.
Support is absolutely necessary.
These glock holders are available in single hook type and double hook type.
The single hook type is tilted about 12 degrees and can be easily mounted.
The double hook type does not incline at 0 degrees and is firmly mounted, and can be mounted with tactical lighting attached as in the attached photo.
Precautions
For a flexible print, print it on a flat side by referring to the screenshot.
Depending on the stacking direction, the direction to withstand the force varies.
You can drop it by inserting and mounting the magazine.
Remove and mount the magazine.
3mag holder
Includes a 3 magazine holder for use with the Glock Stand.
In addition to the Glock magazine, this holder is also loose but compatible with the Beretta m9 magazine.
mesh boeard spec
suare = 50x50mm
wire = 3mm
using double hook
| G19x.stl | 689.2KB | |
| glock_stand_12.stl | 264.4KB | |
| glock_stand_180.stl | 362.7KB | |
| glock_stand_180_gori_1set.stl | 613.1KB | |
| mag_gori.stl | 1.6MB |
