https://www.thingiverse.com/thing:3591043
The previous version I had used shattered 2 times in a row trying to remove a set of Trijicon GL-01 Sights from a Glock 19 Gen 4. So I basically bulked it up a lot, either way I was able to install and remove 5 sets of irons in a row no problem. Even one that was so stuck the pusher which is original decided to give out.
You Will Need:
1x 1/4-20 bolt that is Greater than 5"
5x 1/4-20 nuts grade 5
a wrench or socket to turn the tool
Use one nut against the bolt head, two on either side of the pusher in the hex slots, and the remaining two tightened against each other on the far outside so that the tool cant come out and will ensure that it will spin freely, counter tighten so there is a gap between the inner nut and the pusher frame.
| GLOCK_SIGHT_PUSHER_FRAME_v4.stl | 114.8KB | |
| _Glock_Sight_Pusher_-_Pusher.stl | 39.1KB |
