Gimbal For A SteadiCam 3D Printer Model
The file 'Gimbal For A SteadiCam 3D Printer Model' is (scad,stl,inc) file type, size is 436.8KB.
The file 'Gimbal For A SteadiCam 3D Printer Model' is (scad,stl,inc) file type, size is 436.8KB.
This is a Gimbal designed for a DIY SteadiCam that I made for a colleague at work (See http://www.yb2normal.com/DIYsteadicam.html).
It makes use of two 624 bearings in addition to the required 608 bearing.
It would also be possible to use four 624 bearings or to use no 624 bearings. I thought using two was a good compromise. If you decide to use no 624 bearings then the height of the middle ring can be reduced to 16mm (same as the outer ring) or even 12mm.
| gimbal.scad | 1.7KB | |
| Gimbal.stl | 3.1MB | |
| inner_ring.stl | 1.0MB | |
| mendel_misc.inc | 5.8KB | |
| middle_ring.stl | 1.1MB | |
| outer_ring.stl | 1.0MB |
