Surface enclosure for Giandel Inverter stop/start/status switch. Replaces the provided in-panel mount that comes with the unit. Avoids having to cut a hole in your wall panel. Mount it with velcro or Command strips; in my case I have the switch movable on my desk because I fear commitment.
Bottom panel is tight enough it snaps in, but there are 1mm screw holes available. The switch is supported by the cable against the back plate.
The box uses the mounting plate generated from an older version of the SCAD, used for an electrical outlet wall plate. The SCAD is included if you want to build your own enclosure around the Giandel mount. v2 adds clips to hold the mini circuit board better, and an LED light separator for the surface mounted LEDS on newer revisions of the board.
| giandel.stl | 117.1KB | |
| giandel_v2.scad | 1.9KB | |
| inverter_switch_bottom.stl | 17.3KB | |
| inverter_switch_box.stl | 301.2KB |
