As the name implies, here is a PKE METER design similar to the one in the movie; Ghost Busters. Print this and use it to complete your ghost busters prop set or costume. Being a designer, I've improved the design a bit, so this PKE meter is not %100 same with the one in the movie, a bit smaller to fit smaller printers, better buttons and minor changes at the details. Internals should be quite different as i've never seen the inside of the original. :D
I've cut the big body parts in two to fit in smaller printers. Also added internal details to screw them back to each other after printing. A bit of epoxy glue should also be fine. I managed to print this on my UP printer and glued them with epoxy. I've used the internal screws to secure parts together while glue sets, later removed them.
Have fun.
https://www.youtube.com/watch?v=zuBJWYZohTs
https://www.youtube.com/watch?v=TwNLYC2PqbE
Recently I've published an instructable about building one of these, including circuit schematic and the hex code for the microcontroller.
here it is
http://www.instructables.com/id/Ghost-Busters-PKE-Meter/
| body_bottom.STL | 2.8MB | |
| body_top.STL | 1.7MB | |
| buttons.STL | 1.3MB | |
| ear_left.STL | 481.1KB | |
| ear_left_top.STL | 219.5KB | |
| ear_right.STL | 472.6KB | |
| ear_right_top.STL | 219.4KB | |
| handle_bottom.STL | 913.9KB | |
| handle_top.STL | 736.8KB | |
| knob.STL | 853.9KB |
