SUPER SIMPLE JIG - READ!!!!
Ok I took the entire PDF, converted to STL then cut up into about 200x200 sections. This is a down and dirty simple jig that should suffice for people that wanted one to at least be able to get 90-95% of it aligned. Each piece is numbered by coordinates an I included the full map so you can see where Z1Y1X1 starts and such. I resized the cat to 102% before cutting it out of the cube so it should give a little wiggle room to be able to remove the jig after you put the pieces on the wall.
CHANGE Z HEIGHT TO YOUR LAYER HEIGHT on each piece, or whatever you want really but I was thinking to keep this super thin and just use scotch tape to stick it on the wall as a guide. It will take a while to print but people were asking for it so I figured, why not. I figured someone will see this and maybe do a nicer one that has cuts along the parts so it doesn't have anything hanging away from the main body but if not, should be good enough I think.
This would be a great use for that super cheap color change filament you can get from iiidmax
| SrcMesh.stl | 549.3KB | |
| Z1_Y1_X1.stl | 289.2KB | |
| Z1_Y1_X2.stl | 423.5KB | |
| Z1_Y1_X3.stl | 293.1KB | |
| Z1_Y1_X4.stl | 320.8KB | |
| Z1_Y1_X5.stl | 89.9KB | |
| Z1_Y1_X6.stl | 106.9KB | |
| Z1_Y1_X7.stl | 111.3KB | |
| Z1_Y1_X8.stl | 85.2KB | |
| Z1_Y2_X1.stl | 72.6KB | |
| Z1_Y2_X2.stl | 255.7KB | |
| Z1_Y2_X3.stl | 224.2KB | |
| Z1_Y2_X4.stl | 217.7KB | |
| Z1_Y2_X5.stl | 112.8KB | |
| Z1_Y2_X6.stl | 99.4KB | |
| Z1_Y2_X7.stl | 89.4KB | |
| Z1_Y2_X8.stl | 77.8KB | |
| Z1_Y3_X1.stl | 110.4KB | |
| Z1_Y3_X2.stl | 340.5KB | |
| Z1_Y3_X3.stl | 369.6KB | |
| Z1_Y3_X4.stl | 147.5KB | |
| Z1_Y3_X5.stl | 139.6KB | |
| Z1_Y3_X6.stl | 125.3KB | |
| Z1_Y3_X7.stl | 93.7KB | |
| Z1_Y3_X8.stl | 80.6KB | |
| Z1_Y4_X1.stl | 75.4KB | |
| Z1_Y4_X2.stl | 293.7KB | |
| Z1_Y4_X3.stl | 322.4KB | |
| Z1_Y4_X4.stl | 106.5KB | |
| Z1_Y4_X5.stl | 121.8KB | |
| Z1_Y4_X6.stl | 621.5KB | |
| Z1_Y4_X7.stl | 849.8KB | |
| Z1_Y4_X8.stl | 162.0KB |
