Geo/Chevy Tracker First Gen Skull Knob For Heat And A/c Controls 3D Printer Model
The file 'Geo/Chevy Tracker First Gen Skull Knob For Heat And A/c Controls 3D Printer Model' is (stl) file type, size is 2.5 MB.
The file 'Geo/Chevy Tracker First Gen Skull Knob For Heat And A/c Controls 3D Printer Model' is (stl) file type, size is 2.5 MB.
I created this for first generation trackers?sidekicks/Suzukis heater A/C control knobs to be press fit replacements for stock lever knobs. Best done on resin printer but can be done on fdm with small enough nozzle and the right settings for detail. If done on resin printer make sure the skulls are oriented correctly to allow for draining of the slot in the back. the slot point upwards towards the top of the head as it gets deeper to allow for it to sit correctly when installed. If printed in resin just coat them in a UV protective clear coat spray paint or paint them in general to protect them from over curing from the sun.
Probably best resized in your slicer to be 105% or 106% because even though i measured they still came out a little small and even at 104% they fit very very tight.
| tracker_skull_knob_final_render.stl |
