I made this hook for my Spiderbeam rod. The diameter of the tip is 6,5-6,6mm so I made the hole with 7mm diameter. You need 2 screwes M6 with nuts, it holds very good without force, you need to tighten the screws very smoothly. It will fit for pole fishing rods with the same diameter.
The hook is printed separately, so you can print and replace it, when it break. For the connection with the basis you need a M6 screw with nut. You can also turn the hook 180° so it points down, in the case you have to pull something down.
Printed with 80% infill grid.
| Haken_v2.stl | 13.1KB | |
| spiderbeam_GC_tools_nur_Block_mit_7mm_und_Aufnahme_Haken_v1.stl | 107.1KB |
