Gengar Ornament Planter 3D Printer Model
The file 'Gengar Ornament Planter 3D Printer Model' is (stl) file type, size is 80.5MB.
The file 'Gengar Ornament Planter 3D Printer Model' is (stl) file type, size is 80.5MB.
Hey guys! All the credit goes to @Psdwizzard (https://www.thingiverse.com/thing:5028132).
All I did was make a hole on Gengar to add your favorite succulents! The hole is 60mm in diameter, so no need to scale (I made a little drainage hole as well, everything is considered!). It prints in under 100g of filament with tree supports.
This file is HUGE. Please, allow CURA a few minutes to load the STL (Don't get exhausted if it takes 3 minutes to open the file and another 3min to slice)
Here are my print settings...
Layer height: 0.2mm
Walls: 3
Infill: 12% (Gyroid)
Speed: 60mm/s
Supports Overhang: 80.0 (Tree, Zig Zag, everywhere). I'm sure you can print with fewer supports. I just didn't want a brainer thinking about it. Total supports are about 11g
Build Adhesion: Skirt
Total time: Around 17h
I hope you guys enjoy it!!!! Post your makes with their plants!!!
| gengar_planter.stl | 119.1MB |
