At XMas day i was searching for a Stand for my ipad. I was looking for a small and generic stand, not only for my ipad, but for my cell phone too... So, after searching a bit, i could find one that fit all my needs. So i´ve designed this one. :)
There´s 3 versions...
V01 - Not optimized for printing time. It tooks about 120min using 20% infill and 70mm/s (0.3) - This is a Robust version. V02 - A lighter version, that uses less material and don´t cover the side buttons at the botton. It prints in 60 min... BTW : That little bump on the back pads, is to hold my CameraConnection Kit Cap. ;) V03 - Its an update with more design features, and a mix of v01 and v02. It leaves a space for iphone volume buttons, too. It prints in about 70min.The Stand works well with iPhone 4, 4s, iphone 5s and Ipad 3. They fit perfectly and looks stable even over soft planes, like a bed. I hope you like it !Marcelo Souza
kumodot.com
| Kmdt_UniversalStands_V01.stl | 14.6KB | |
| Kmdt_UniversalStands_V02.stl | 29.8KB | |
| Kmdt_UniversalStands_V03.stl | 47.9KB |
