Gen 6 Subaru Outback Rear Camera Cover 3D Printer Model
The file 'Gen 6 Subaru Outback Rear Camera Cover 3D Printer Model' is (stl) file type, size is 491.4KB.
The file 'Gen 6 Subaru Outback Rear Camera Cover 3D Printer Model' is (stl) file type, size is 491.4KB.
I made this rear camera cover for my 2024 Subaru Outback. It fits all other Gen 6 Subaru Outbacks. I designed it in hope that it will help with the camera staying clean. It gets sandwiched between the washer nozzle and the camera, right at the indentation. Yes it does disable the washer. That was intentional because all the water that runs off the rear window, also runs down that same nozzle and is one of the reasons that it gets dirty to begin with. If you wish to retain the washer, then you need drill a hole in the cover. I made two versions. 2.0 has a larger hood at the top. It stays in place just with the pressure of being sandwiched between the nozzle and the camera, but just in case, on the bottom side, i left some extra room for some double sided tape.
| Rear_Camera_Cover.stl | 617.7KB | |
| Rear_Camera_Cover_2.0.stl | 771.4KB |
