Gen 1 Ford F150 Raptor Air Conditioner AC Vent 2″ Viair Gauge Mount 3D Printer Model
The file 'Gen 1 Ford F150 Raptor Air Conditioner AC Vent 2″ Viair Gauge Mount 3D Printer Model' is (stl) file type, size is 113.3KB.
The file 'Gen 1 Ford F150 Raptor Air Conditioner AC Vent 2″ Viair Gauge Mount 3D Printer Model' is (stl) file type, size is 113.3KB.
Gen 1 Ford Raptor Air Vent Gauge Mount
I've seen mounts online in the $50 range(plus shipping) so I figured I'd give it a go. It still allows some air to pass through but you can't point the direction since that's the part you're replacing.
I also decided to add a selenoid to drain water out of the bottom with a button. I found these tiny push buttons. Whether or not you're using this for an air gauge or boost gauge, You might find the switch location useful.
Edit:
I evened out the holes a bit. It was really not noticeable but when I redesigned for the button, I tried to do a better job of spacing everything.
| GaugeRingAllHoles.stl | 242.4KB | |
| RaptorVentGaugeButton1.stl | 255.0KB |
