This Filament holder is designed to clip around the acrylic Z Top Mounts (either the right or left) and screw directly into the frame using extra socket cap screws that came with the Geeetech. Counter bores on the inside account for the possibility that the threaded rod and smooth rod may extend above the z mount.
I opted to design my own filament holder because I did not want to stress the acrylic frame using a straddling style mount. I also did not want to drill new holes through the frame.
This mount will support dual head extruders as well.
This filament holder should work with any of the Geeetech 8 mm frames.
For those who want to use 1/2" schd 40 PVC, I've included end caps to prevent the pipe from walking off the brackets.
Update: I've included a flat base for those who just want to place their filament holder on a desktop or side surface.
| Filament_Holder_Base_Left.stl | 204.3KB | |
| Filament_Holder_Base_Left_Through_Hole.stl | 189.8KB | |
| Filament_Holder_Base_Right.stl | 204.3KB | |
| Filament_Holder_Base_Right_Through_Hole.stl | 189.8KB | |
| Filament_Holder_Side_v2.stl | 83.4KB | |
| Flat_Base.stl | 126.5KB | |
| PVC_End_Cap.stl | 419.2KB | |
| Spool_Shaft.stl | 268.4KB |
