There are plenty very nice housings for Arduino&RAMPS but not a single one for the Chinese all-in-one version GT2560.
Attention: There are different board sizes out there. The dimensions of the hollow for the board are 110mm x 79.8mm x 36.8mm for the default version. A "universal" version is provided which should fit all board lengths.
It took me probably one hour to nicely fit the cables within the box. But it was worth the effort. You'll need four 20mm M3 screws and appropriate nuts as well as any four M4 screws.
See also this dust filter for the 80mm fan: http://www.thingiverse.com/thing:1284759
STEP and Solidworks (for SW you also need the other SLDPRT file) files are provided if you have to adjust the mounting holes or wish to add further openings.
[Updates]
-Added a version without the chamfers within the honeycomb-structure on the sides to improve print-ability.
-Added an universal version which should fit all GT2560 boards.
-Added a sealed version with two 40mm fans for an optimized airflow. Cleaned up history of SLDPRT file.
-Added a version for boards which are 81mm wide (version A+). Attention: Only the corresponding 81mm lid will fit.
| GT2560-housing.SLDPRT | 7.2MB | |
| m4_thread-cutter.SLDPRT | 1.1MB | |
| set_frame.STEP | 18.3MB | |
| set_frame.STL | 6.3MB | |
| set_frame_40mm_fan.STEP | 15.1MB | |
| set_frame_40mm_fan.STL | 5.0MB | |
| set_frame_81mm-wide.STL | 5.0MB | |
| set_frame_universal.STEP | 15.8MB | |
| set_frame_unversal.STL | 5.0MB | |
| set_frame_v1.1.STEP | 15.5MB | |
| set_frame_v1.1.STL | 5.0MB | |
| set_lid.STEP | 18.2MB | |
| set_lid.STL | 610.5KB | |
| set_lid_40mm_fan.STEP | 3.5MB | |
| set_lid_40mm_fan.STL | 674.5KB | |
| set_lid_81mm-wide.STL | 588.6KB | |
| set_lid_intelFan-92.4mm.STL | 571.2KB | |
| set_lid_plain.STEP | 19.4MB | |
| set_lid_plain.STL | 537.9KB |
