WORK IN PROGRESS
TRAVAIL EN COURS
Fidget spinner for 22mm bearings (608 . .)
Press fit between the bearings and the gears.
Place the three bearings in the support with the axes (support_spinner_engrenage_male) and the last one in the middle, then clip with the other support.
There is a bit of play between the middle gear and the others, so the center of mass is not always in the middle, the spinner may wobble while spinning.
The gears don't turn free enough.
This is my first spinner, gear, and clip design, feel free to comment for advice.
| engrenage_spinner_roulement.stl | 709.2KB | |
| support_spinner_engrenage_femelle.stl | 3.4MB | |
| support_spinner_engrenage_male.stl | 3.8MB | |
| support_spinner_engrenage_top_V2.stl | 3.2MB | |
| support_spinner_engrenage_V2.stl | 3.2MB |
